JDLB Make selection

The following headings contain information and facts on important elements for assortment and correct use of ギアボックス.
For specific data to the gearbox assortment,see the relevant chapters.
1.0 OUTPUT TORQUE
one.one Rated output torque
Mn2 [Nm]
The torque that could be transmitted constantly by the output shaft, together with the gear unit operated below a service component fs = one.
1.2 Essential torque
Mr2 [Nm]
The torque demand based on application requirement. It truly is advisable for being equal to or significantly less than torque Mn2 the gearbox under examine is rated for.
one.three Calculated torque
Mc2 [Nm]
Computational torque worth to get employed when deciding on the gearbox.
It is calculated thinking about the expected torque Mr2 and support element fs, as per the relationship here following:Mc2 = Mr2 ?¡è fs ?¨¹ Mn2
2.0 Energy
2.one Rated input power
Pn1 [kW]
The parameter might be uncovered during the gearbox rating charts and represents the KW that may be safely transmitted towards the gearbox, based on input pace n1 and support issue fs= 1.
2.2 Rated output energy
Pn2 [kW]
This value will be the energy transmitted at gearbox output. it might be calculated with the following formulas:
Pn2 = Pn1 ?¡è |?d
Pn2= Mn2*n2/9550
3.0 EFFICIENCY
Efficiency is a parameter which includes a main influence to the sizing of selected applications, and essentially relies on gear pair designelements. The mesh data table on webpage 9 shows dynamic efficiency (n1=1400)and static efficiency values.
Don't forget that these values are only achieved after the unit has been run in and it is in the doing work temperature.
3.one Dynamic efficiency
[|?d]
The dynamic efficiency would be the connection of electrical power delivered at output shaft P2 to power applied at input shaft P1:
|?d =P2/P1
three.two Static efficiency[|?s]
Efficiency obtained at start-up with the gearbox. Even though this is commonly not major aspect for ヘリカルギア, it could be as a substitute significant when deciding on worm gearmotors operating beneath intermittent duty.
four.0 Services Issue
The service aspect (fs ) is determined by the working circumstances the gearbox is subjected to the parameters that have to be taken into consideration to pick one of the most sufficient servies component properly comprise:
1. type of load with the operated machine : A – B – C
2. length of everyday working time: hours/day(?¡Â)
3. start-up frequency: starts/hour (*)
Form of LOAD: A – uniform,fa?¨¹0.three
B – reasonable shocks, fa?¨¹3
C – heavy shocks, fa?¨¹10
fa=Je/Jm
–Je(kgm2) second of the external inertia reduced on the drive shaft
–Jm(kgm2) minute of inertia of モーター
–If fa>10 please contact our Technical Services
A -Screw feeders for light products, followers, assembly lines, conveyor belts for light materials, tiny mixers, lifts, cleansing machines, fillers, manage machines.
B -Winding units, woodworking machine feeders, items lifts, balancers,threading machines, medium mixers, conveyor belts for hefty resources,winches, sliding doors, fertilizer scrapers, packing machines, concrete mixers, crane mechanisms, milling cutters, folding machines, gear pumps.
C -Mixers for hefty resources, shears, presses, centrifuges, rotating supports, winches and lifts for hefty products, grinding lathes, stone mills, bucket elevators, drilling machines, hammer mills, cam presses, folding machines, turntables, tumbling barrels, vibrators, shredders.